YAMAHA RAPTOR 350 Removing stock carburetor and cables

download
remove seat and gas tank. Make sure fuel petcock is in “off” position. 2. Remove throttle cable paying close attention to routing, as the new cable (s) will need too be routed the same. 3. Remove stock carburetor and stock throttle housing. Stuff a clean, dry rag into manifold to keep debris out of motor. 4. Remove stock air box. 5. Remove choke cable from handlebars. 6. Remove carb vent line from bike. Carburetor installation 1. Carefully trim the rubber alignment tab off of the face of the manifold with a razor blade or side cutters. 2. Remove the hex pipe plug from the carb cap using a 11mm or 7/16 wrench. Do not discard plug, as it will be needed later. Install the metering adjustment tool included in the hardware kit. Do not over-tighten as damage may occur to cap. 3. Attach fuel line to carburetor and secure with clamp. 4. Install remote idle cable into tab on top of carburetor. See main manual for this step. NOTE: Nut must be removed from cable before installation 5. Place carburetor into manifold

Incoming search terms:

• electrical schematics yamaha raptor 350 2005
• raptor 80 carb diagram
• yamaha mz300 carburetor
• yamaha raptor 80 carburetor diagram
• raptor 50 carb
• Yamaha raptor 80 carborator
• where is carborator in raptor 80
• Yamaha PW50 Carb Settings
• fixing air intake on 1980 xt250
• yamaha pw 80 choke settings